![]() ![]() ![]() If this happens, check your coil, make sure it’s connected properly, and ensure the tank is attached properly. If there are any issues and/or problems with the coil, its resistance, or the connection, the mod will simply not fire and likely show an error message. If you’re using homemade coils, the resistance of the coil may differ, but that’s a whole other kettle of fish. The resistance of the coil, once installed, is shown with the Ohms symbol (Ω) – 0.18Ω, for instance. You can run into issues with your SMOK mod if the coil isn’t set up correctly, though this specific issue mostly affects home-made coils. You shouldn’t have any issues with this, as they’re all calibrated for the purpose. If you’re using one of SMOK’s sub-ohm tanks, you need to make sure that its resistance matches what the coil says on the side. You have wattage and TC readings, dual-battery readouts, Ohms reading, voltage, and even a puff counter so you can see how much you’re vaping each day. SMOK packs a lot of information into its mods’ displays. #NUMICRO ISP PROGRAMMING TOOL FOR ALIEN V1.3.2 FOR MAC HOW TO#How To Use SMOK Mods: Exploring The Display There will be a short boot-up time, where you see the SMOK logo, and then, once all the software is booted, the settings menu will appear on the display. Once you’ve unboxed your SMOK mod, and you have installed the correct batteries in the right orientation, simply click the fire bar FIVE times to wake the mod. This is a great method for firing your mod, as it requires very little precision, you can do it blindly, and the overall motion is more intuitive. The AWESOME SMOK G-Priv 2 – Read My FULL ReviewĪlmost all of SMOK’s recent run of mods utilize a fire bar over a single fire button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |